Table of Contents
Advertisement
3.2.2
Powered by Batteries
When connected to the external AC power supply, the system is powered by the
external power. The lithium ion batteries inside it are in the charging status.
When disconnected from the external power supply, the system is powered by the
lithium ion batteries. Refer to Chapter 15 for the detailed operations and precautions.
3.2.3
Equipotential Terminal
The symbol
represents the equipotential terminal that is used for balancing the
protective earth potentials between the system and other electrical equipment. For the
equipotential terminal location, please refer to "2.8 Power Supply Panel".
WARNING:
3.3
Power ON/OFF
3.3.1
Powering ON the System
CAUTION:
1. Be sure to connect the equipotential wire before
inserting the power plug into the receptacle; be sure
to remove the power plug from the receptacle before
disconnecting the equipotential wire; otherwise
electric shock may result.
2. When you connect another device to this system, you
should use the equipotential wire to connect each of
equipotential terminals; otherwise electric shock may
result.
3. Connect the earth cable before turning ON the
system. Disconnect the earth cable after turning OFF
the system. Otherwise, electric shock may result.
4. DO NOT connect this system to the outlets with the
same circuit breakers and fuses that control the
current to devices such as life-support systems. If
this system malfunctions and generates over-current,
or when there is an instantaneous current at power
ON, the circuit breakers and fuses of the building's
supply circuit may be tripped.
To ensure safe and effective system operation, you must
perform daily maintenance and checks.
If the system begins to function improperly – immediately
stop scanning. If the system continues to function improperly
– fully shut down the system and contact Mindray Customer
Service Department or sales representative.
If you use the system in a persistent improperly functioning
state – you may harm the patient or damage the equipment.
System Preparation 3-3
Advertisement
Table of Contents
