Assembling The Secondary Filtration Filter - Navistar INTERNATIONAL DT 466 Service Manual

OIL SYSTEM MODULE ASSEMBLY AND SECONDARY FILTRATION

Assembling the Secondary Filtration Filter

Figure 432 Secondary filter installation
1. Filter element
2. Filter header
1. Install a new secondary oil filter.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Figure 433 Secondary filter components
1.
2.
3.
4.
5.
6.
2. Place a new O-ring gasket onto filter cover.
3. Position cover onto filter header.
4. Place a new O-ring onto stud assembly and
thread into top of secondary filter cover and
tighten to the special torque value (Table 42).
EGES-265-2
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
Stud assembly
O-ring
Cover
O-ring Gasket
Filter element
Filter header
295