Power Steering Pump Without Air Compressor - Navistar INTERNATIONAL DT 466 Service Manual

414 AIR COMPRESSOR, POWER STEERING PUMP, AND POWER

Power Steering Pump without Air Compressor

NOTE: The following steps are only for applications
that are not equipped with an air compressor.
6
8
7
6
Figure 654 Power steering pump without air compressor
1. Plug assembly, M18 (standard
torque) (General Torque
Guidelines, page445 )
2. Cap
1. Apply a small amount of assembly grease to the
O-ring and install into groove on front cover.
2. Install two power steering pump mounting
bolts (M10 x 90) and nuts (M10) and tighten
to the standard torque value (General Torque
Guidelines, page445 ).
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
TAKE-OFF
5
4
3. Power steering pump assembly
4. Nut, M12 (2)
5. O-ring gasket
6. Bolt, M12 x 90 (2)
EGES-265-2
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
3 2
7. Power steering pump gear nut
and shaft key (supplied with
pump)
8. Drive gear (supplied with pump)
3. Install power steering low-pressure hose.
4. Install power steering high-pressure hose.
1
H16020