Inlet And Egr Mixer Duct - Navistar INTERNATIONAL DT 466 Service Manual

Figure 82 Intake manifold and inlet duct bolt configuration
1. Inlet and EGR mixer support
bolt, M10 x 90
3. Place bolt / stud, (M10 x 35 / 20) into the rear most
bolt hole along the bottom finger tight.
4. Install the remaining short intake manifold
mounting bolts (M10 x 35) finger tight, in their
correct positions. One bolt hole should remain
open for later installation of the inlet and EGR
mixer support and bolt.
5. Connect injectors and anchor harness.
6. Connect harness to MAP and MAT sensors.

Inlet and EGR Mixer Duct

Figure 83 Inlet and EGR mixer gasket
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
INTAKE, INLET, AND EXHAUST MANIFOLDS
1
2. Bolt, M10 x 35 (12)
3. Bolt / Stud, M10 x 35 / 20
EGES-265-2
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
1. Install inlet and EGR mixer with new gasket.
Figure 84 Mounting the inlet and EGR mixer
1. Inlet and EGR mixer support bolt, M10 x 90
2. Inlet mixer bolts, M8 x 60 (4)
2. Install four bolts (M8 x 60) that hold the inlet and
EGR mixer to the intake manifold, but do not
tighten.
3. Thread the inlet and EGR mixer duct support bolt
(M10 x 90) finger tight.
87
2
3
H14026