Specifications; Special Torque - Navistar INTERNATIONAL DT 466 Service Manual

Specifications
Table 46 Fuel System Specifications
Fuel heater switching points
Fuel pressure regulator assembly opening pressure
Fuel strainer
High-pressure oil manifold, range

Special Torque

Table 47 Fuel System Special Torques
Bolt, M8 x 20
Drain valve
Elbow jam nut
End plug assembly (AWA) or attenuator
Fitting assembly, 3/8 tube
Fuel bowl
Fuel drain plug
Fuel fitting
Fuel filter header mounting bolts, M8 x 100
Fuel filter housing cover
Fuel pressure regulator
Fuel valve assembly (air bleed and pressure test port)
High-pressure oil hose fitting, M18 (at head)
High-pressure oil hose (swivel nuts)
High-pressure oil manifold bolts, M8 x 90
High-pressure oil pump assembly bolts
High-pressure oil pump assembly (gear)
Injector hold down clamp assembly
IPR valve assembly
Low-pressure fuel pump bolts, M6 x 16
Low-pressure fuel pump tube coupling nuts
Plug assembly, M12 (intake manifold fuel rail)
Post
Self tapping screw
Water In Fuel (WIF) sensor
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
FUEL SYSTEM
EGES-265-2
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
On: 2 °C (36 °F)
Off: 24 °C (75 °F)
448 - 517 kPa (65-75 psi)
150 micron
5 - 28 MPa (725 - 4,075 psi)
29 N·m (21 lbf·ft)
0.5 -1 N·m (5 -10 lbf·in)
88 N·m (65 lbf·in)
204 N·m (150 lbf·ft)
27 N·m (20 lbf·ft)
39 N·m (29 lbf·ft)
24 N·m (18 lbf·ft)
27 N·m (20 lbf·ft)
27 N·m (20 lbf·ft)
25 N·m (18 lbf·ft)
1 - 1.7 N·m (10 -15 lbf·in)
15 N·m (132 lbf·in)
54 N·m (40 lbf·ft)
46 N·m (34 lbf·ft)
27 N·m (20 lbf·ft)
30 N·m (22 lbf·ft)
231-279 N·m (170 - 205 lbf·ft)
41 N·m (30 lbf·ft)
50 N·m (37 lbf·ft)
15 - 18 N·m (132 - 160 lbf·in)
18 N·m (155 lbf·in)
24 N·m (18 lbf·ft)
8 N·m (72 lbf·in)
5 N·m (41 lbf·in)
1.7 N·m (15 lbf·in)
363