Vibration Damper Assembly - Navistar INTERNATIONAL DT 466 Service Manual

192
7. Retighten three M12 x 40 damper bolts in
sequence to special torque (Table 20) several
times until each bolt has no movement.

Vibration Damper assembly

Three Rubber Vibration Damper Kits are available
for International® DT 570 and HT 570 Diesel
Engines. See (TSI-08-12-20 Rubber Vibration
Damper Replacement Kits, page480 ).
CAUTION: To prevent engine damage, verify damper
hub dowel pin is aligned with dowel hole of the
vibration damper assembly.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
FRONT COVER AND RELATED COMPONENTS
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
Figure 266 Vibration damper assembly
1. Vibration damper
2. Bolt, M10 x 16 (6)
3. Dowel pin
1. Align dowel hole in vibration damper with dowel
pin on damper hub and install six M10 x 16 bolts
finger tight.
2. Torque bolts to special torque (Table 20).
EGES-265-2