Oil Level Gauge - Navistar INTERNATIONAL DT 466 Service Manual

5. Remove the nut (M10) securing the vent and drain
tube to the intake manifold.
6. Carefully pull breather assembly out of valve
cover.
7. Remove breather and tubing assembly and place
in solvent wash tank.

Oil Level Gauge

7
Figure 361 Oil level gauge assembly
1. Bolt, M6 x 40
2. Nut, M6
3. Cushioned clamp
1. Remove the oil filler tube bolt (M6 x 40) and nut
(M6) at the fuel filter bracket.
2. Remove the tube clamp at the crankcase and
discard oil dipstick tube seal.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
CRANKCASE, CRANKSHAFT, AND CAMSHAFT
2
3
4
4. Oil filler tube
5. Tube clamp
6. Oil level gauge tube
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
1
5
6
3. If necessary, remove oil level gauge tube from
crankcase by using a brass drift and hammer.
EGES-265-2
H06082
7. Oil dipstick tube seal
255