Disassembling Piston And Connecting Rod Assembly - Navistar INTERNATIONAL DT 466 Service Manual

Figure 302 Removing connecting rod cap and
bolts
5. Unscrew the bolts completely. Remove the cap
and bolts as a unit.
6. Discard connecting rod cap bolts.
Figure 303 Pushing out piston and connecting
rod assembly
7. Do not push on rod fractured surface. Use a
hammer with a plastic or wooden handle or a
non-marring punch to push the piston out of the
cylinder sleeve.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
POWER CYLINDERS
Figure 304 Removing piston and connecting
rod assembly from cylinder sleeve
8. Once the piston rings are free of the cylinder
sleeve, remove the assembly from the top of the
crankcase.
9. For installation purposes, mark each piston,
connecting rod, and cap with the cylinder number
from which it was removed. Also mark the front
of each piston as it was installed in the engine.
Disassembling Piston and Connecting Rod
Assembly
injury or possible death, wear safety glasses
when removing piston pin retaining rings.
Figure 305 Removing piston pin retaining rings
EGES-265-2
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
WARNING: To prevent serious personal
219