Cleaning And Inspection; Checking Wiring Harness And Electrical Connectors - Navistar INTERNATIONAL DT 466 Service Manual

Cleaning and Inspection

Checking Wiring Harness and Electrical
Connectors
1. Check the connector pins on all electrical
components. If any pins are bent, replace
component.
2. Check each wiring harness for worn flexible
conduit, and heat damage to wiring. Repair or
replace each wiring harness as necessary.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
ENGINE ELECTRICAL
3. Check each wiring harness connector for
corrosion (green or gray and white deposits
on the terminals), female connector sleeves that
are spread open, and terminals that are pushed
back relative to the other terminals in the same
connector.
terminals as necessary.
4. Inspect vibration isolator grommets for wear. If
worn, install new grommets.
EGES-265-2
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
Replace damaged connectors and
319