Installation; Roller Tappets; Installing The Cylinder Head - Navistar INTERNATIONAL DT 466 Service Manual

144

Installation

Roller Tappets

Figure 194 Roller tappets and guide
1. Lubricate roller tappets with clean engine oil.
2. Install each roller tappet and guide into tappet
bore. Install used roller tappets in their original
locations, revolving in the same direction as
before removal.

Installing the Cylinder Head

NOTE: Before cylinder head installation, check
cylinder sleeve protrusion (Checking Cylinder Sleeve
Protrusion, page229 ).
1. Install two lifting eyes with four bolts (M12 x 25)
onto cylinder head. Tighten bolts to the standard
torque value (General Torque Guidelines, page
445 ).
2. Clean and dry the cylinder head gasket surface.
Also use the correct size tap to clean head bolt
holes in the crankcase.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
CYLINDER HEAD AND VALVE TRAIN
EGES-265-2
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
Figure 195 Installing alignment dowels
3. Install or verify that alignment dowels are in the
top of the crankcase.
Figure 196 Installing cylinder head gasket
1. Alignment dowels
4. Install a new cylinder head gasket over the
alignment dowels.