Crankshaft Timing Disk - Navistar INTERNATIONAL DT 466 Service Manual

382
Figure 607 Installing rear oil seal installer onto
base
5. Place oil seal installer up to steel face of seal and
gently push by hand into flywheel housing as far
as possible.
Figure 608 Installing the rear oil seal
6. Put washer and forcing nut onto shaft and tighten
until rear oil seal bottoms out in flywheel housing.
The seal will be placed at the correct location
(depth).

Crankshaft Timing Disk

NOTE: Alignment dowel pin convex end must
protrude out of crankshaft (Figure 583).
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
FLYWHEEL AND FLYWHEEL HOUSING
EGES-265-2
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
Figure 609 Crankshaft timing disk alignment
dowel
7.6 mm
(0.300 in)
3
Figure 610 Crankshaft timing disk alignment
dowel details
1. Crankshaft timing disk
2. Crankshaft
3. Alignment dowel (convex end)
2
1
H07032