Camshaft Assembly - Navistar INTERNATIONAL DT 466 Service Manual

266
Figure 381 Pulling in the front bushing
7. Install the front bushing through the front of the
crankcase. Pull the bushing into place from the
rear of the crankcase by turning the pulling nut on
the puller screw. Remove the installation tool and
inspect the oil hole alignment.
8. Install the rear bushing through the rear of the
crankcase. Pull the bushing into place from the
front of the crankcase by turning the pulling nut
on the puller screw. Remove the installation tool
and inspect the oil hole alignment.
9. Install camshaft seal ring in rear of crankcase.

Camshaft Assembly

NOTE: Use this procedure to install the cam gear and
camshaft as a unit.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
CRANKCASE, CRANKSHAFT, AND CAMSHAFT
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
Figure 382 Installing camshaft assembly
1. Rotate crankcase to a vertical position.
2. Lubricate all camshaft journals and bushings with
clean engine oil.
3. Install the camshaft assembly in the crankcase.
Figure 383 Torquing camshaft thrust plate bolts
4. Install the two camshaft thrust plate bolts (M8 x
20). Tighten the bolts to the special torque value
(Table 39).
EGES-265-2