Installing The Oil Pan - Navistar INTERNATIONAL DT 466 Service Manual

4. Torque bracket bolt (M10 x 25) to the special
torque value (Table 23).

Installing the Oil Pan

1
4
4
Figure 292 RTV sealant locations – see inset (typical)
1. Front cover (front half)
2. Front cover (rear half)
3. Gasket
1. Apply a circular dab of T-442 Wacker RTV
sealant (Table 24) approximately 19 mm (0.75 in)
in diameter to the six locations on the crankcase
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
OIL PAN AND OIL SUCTION TUBE
3
2
4
4
4. Sealant, Wacker T-442, (6
locations)
5. Crankcase
EGES-265-2
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
(x 6)
5
6.
mounting surface. These locations coincide with
gasket joints between the front cover halves,
crankcase, and flywheel housing.
6
4
4
H06031
Flywheel housing
209