Generation 1 (Mounting Bolts) - Navistar INTERNATIONAL DT 466 Service Manual

Generation 1 (Mounting Bolts)

2
Figure 252 Front cover mounting bolts – front half (Generation 1)
1. Front cover (front half)
2. Hex flange bolt, M8 x 45 (6)
1. Position the forward half of the front cover onto the
rear half of the front cover using the two dowels as
a guide.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
FRONT COVER AND RELATED COMPONENTS
3, 4
2
1
3. Hex flange bolt, M8 x 40 (4),
Note: Bolts marked A to be
inserted from rear side of cover.
4. Hex flange nut, M8 (8)
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
A A
A
6
7
Thread all mounting bolts finger tight, then tighten
bolts to the standard torque value (General
Torque Guidelines, page445 ).
EGES-265-2
5, 4
3, 4
5, 4
H06078
5. Hex flange bolt, M8 x 30 (4)
6. Heavy hex flange bolt, M10 x 25
(2) (PTO equipped engines only)
7. Dowel hole
185