Rear Oil Seal - Navistar INTERNATIONAL DT 466 Service Manual

Rear Oil Seal

Figure 603 Applying sealant to the crankshaft
and seal assembly
1. Apply a 360° bead of Loctite® hydraulic sealant
to the crankshaft where the rear oil seal assembly
will be positioned.
Figure 604 Installing the rear oil seal installer
base
2. Install base component of oil seal installer onto
crankshaft and tighten bolts (2).
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
FLYWHEEL AND FLYWHEEL HOUSING
EGES-265-2
Follow all warnings, cautions, and notes.
© 2009 Navistar, Inc.
Figure 605 Applying sealant to the seal
assembly
3. Apply a 360° bead of Loctite® hydraulic sealant to
the outside diameter of the rear oil seal assembly.
Figure 606 Placing oil seal onto rear oil seal
installer base
4. Orient steel face of oil seal outward (towards
transmission) and start seal onto oil seal installer
base.
381