Table of Contents
Advertisement
Define the attributes of an IPDS transaction setup
A transaction setup with the status [Opened], can be adjusted. (
page
112)
1. Open the Settings Editor and go to: [Transaction printing]→[Transaction setups].
[134] [Transaction setups] tab
2. Check that the transaction setup you want to change has the status [Opened]. (
transaction setup to change attributes on page
3. Click the [IPDS transaction setup] tab.
[135] [IPDS transaction setup] tab
4. Change the attributes one by one or click [Edit] in the title bar to adjust the attributes of a
group in one dialog.
5. Validate the transaction setup. (
6. Make sure that you reload a transaction setup that is active when you make the changes.
Load a transaction setup on page
(
Define the IPDS settings
[136] IPDS transaction setup attributes
[IPDS] attributes
[Tray selection mecha-
nism]
[Data resolution]
[Default output tray]
116)
Validate a transaction setup on page
114)
Description
A transaction printing job always uses the media definitions as
specified in Settings Editor.
Select [Tray to tray] or [Tray to media].
The IPDS data stream contains a reference to a logical tray. There
are 36 logical trays that can be assigned to a physical paper tray
([Tray to tray]) or to media of the media catalog ([Tray to media]).
Define the tray-to-media mapping on page
(
to-tray mapping on page
Select the resolution of the bitmaps the printer accepts.
Select the default output tray.
Define the attributes of an IPDS transaction setup
Learn about transaction setups on
124)
118,
119)
Chapter 7 - Transaction printing
Open a
Define the tray-
4
117
Advertisement
Table of Contents
