Table of Contents
Advertisement
Remove sheets from the printheads
Remove sheets from the printheads
When sheets stuck to the printheads, a message appears on the control panel to remove the
sheets. A paper jam in the print module can cause a polluted print belt. When you have removed
the paper, ensure that there are no dirt particles left on the print belt. Clean the print belt in case it
is dirty from the stacked sheets.
[472] Location of the print module
Before you begin
• You need to have the rights to access the maintenance tasks and the configuration settings.
• You need cleaning cloths (Alphawipe pads Texwipe TX1004).
• You need a bottle with process maintenance liquid (PML).
NOTE
• In order to keep your hands clean, it is advised to use nitrile gloves when you work with ink,
ColorGrip, or PML. For details see the related material safety data sheets. (
consumables on page
• When you spill any liquid, wipe up the drops with disposable towels and transfer the used
towels to a sealable container appropriate for disposal.
Procedure
Action
1
In the action required screen, touch [Unlock] to unlock the doors of the print module.
2
Open the lower and the upper front doors of the print module.
3
Remove all sheets and snippets from the print belt and the printheads.
Make sure no snippets are left behind.
4
Close the upper and lower front doors.
5
To check if the stacked sheets dirtied the print belt:
Touch [Confirm] on the control panel. The printhead unit moves to the maintenance posi-
tion.
6
Open the lower and the upper front doors of the print module.
408
Chapter 14 - Problem Solving
332)
VarioPrint i-series
4
Advertisement
Table of Contents
