Oce VarioPrint i Series Operation Manual page 22

Hide thumbs Also See for VarioPrint i Series:
Table of Contents

Advertisement

Power source
WARNING
• Put the power plug directly into a power outlet that has the same configuration as the plug.
The use of an adapter can result in an inadequate power supply. If a proper power outlet is
not available, ask a qualified electrician to carry out the installation.
IMPORTANT
• Consult your authorized service representative before you connect other equipment to the
same power outlet.
• Do not connect the machine to a mains voltage or frequency which differs from the value
stated on the power marking label.
NOTE
• When a connection to a different mains voltage is required, contact your authorized service
representative.
Power cord
WARNING
• Do not scratch, abrade, heat, twist, bend, or place a heavy object on the power cord or cause
any other damage to it. The use of a damaged power cord (e.g. exposed core wire or broken
wire) could result in an electrical shock, fire or malfunction of the machine. When you find
any of these conditions, immediately turn OFF the power switch and unplug the power cord
from the power outlet. Then call your authorized service representative.
• Do not use an extension cord to connect the machine.
• Do not use any power cord other than the one provided. Never use the power cord with any
other electrical device.
• Do not route the power cords in such a way that they can be stepped on or tripped over.
Power plug
WARNING
• If the machine is connected via a wall socket, place the machine close to a wall socket that is
easily accessible. The power plug serves as a disconnecting device.
• If the machine is connected via a fixed connection to the electricity grid, the power supply
systems must be easily accessible.
• Do not use the power plug to disconnect the mains power from the machine. Use the
disconnect device to remove the power from the machine.
• The power plug is the disconnect device for the PRISMAsync controller.
• The power plug is the disconnect device for the Service Control Module.
22
Chapter 2 - Safety and Environment Information

Advertisement

Table of Contents
loading

Table of Contents