Table of Contents
Advertisement
Action
2
The LEDs of containers that are empty are off.
Press the connector of the supply tube of the
empty container and disconnect the tube.
3
Take out the empty container and place the empty container next to the full container.
4
Unscrew, swap, and fasten the caps of both con-
tainers.
5
Place the full container in the tray.
6
Carefully connect the supply tube.
7
Press the green button to confirm that you
placed a full container.
The LED blinks slowly for about 10 seconds
while the RFID tag of the container is read. Then
the LED remains on.
NOTE
When the LED continues to blink fast,
there is important information that you
need to read on the control panel.
8
Close the tray of the ink cabinet. Push carefully to prevent that ink comes in the air filter of
the supply tube.
Replace a container in the ink cabinet with drawers
Chapter 13 - Maintain the printer
341
Advertisement
Table of Contents
