Signals From Nc (Db10); Plc Basic Program (P3) - Siemens SINUMERIK 840D sl Function Manual

DB10
DBX56.2 Acknowledge emergency stop
Special cases, The emergency stop state cannot be reset using the interface signal:
errors, ...... DB21, ... DBX7.7 (reset).
Corresponding to ... DB10 DBX56.1 (Emergency stop)
DB10 DBX106.1 (emergency stop active)
DB11 DBX0.7 (mode group reset)
19.8.2

Signals from NC (DB10)

DB10
DBX106.1 Emergency stop active
Edge evaluation: No
Signal state 1 or The NC is in the emergency stop state.
edge change
0 → 1
Corresponding to ... DB10 DBX56.1 (Emergency stop)
DB10 DBX56.2 (acknowledge emergency stop)
19.9

PLC basic program (P3)

To describe the NC/PLC interface signals, refer to:
References:
Functions Manual, Basic Functions; PLC Basic Program (P3)
Chapter: "Signal/Data Specifications"
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Signal(s) updated: Cyclically
Z1: NC/PLC interface signals
19.9 PLC basic program (P3)
1631