Channelspecific Machine Data - Siemens SINUMERIK 840D sl Function Manual

W1: Tool offset
18.16 Data lists
Number Identifier: $MN_
18105 MM_MAX_CUTTING_EDGE_NO
18106 MM_MAX_CUTTING_EDGE_PERTOOL
18108 MM_NUM_SUMCORR
18110 MM_MAX_SUMCORR_PER_CUTTEDGE
18112 MM_KIND_OF_SUMCORR
18114 MM_ENABLE_TOOL_ORIENT
18116 MM_NUM_TOOL_ENV
18.16.1.2

Channelspecific machine data

Number Identifier: $MC_
20096 T_M_ADDRESS_EXT_IS_SPINO
20110 RESET_MODE_MASK
20120 TOOL_RESET_VALUE
20121 TOOL_PRESEL_RESET_VALUE
20125 CUTMOD_ERR
20126 TOOL_CARRIER_RESET_VALUE
20127 CUTMOD_INIT
20130 CUTTING_EDGE_RESET_VALUE
20132 SUMCORR_RESET_VALUE
20140 TRAFO_RESET_VALUE
20180 TOCARR_ROT_ANGLE_INCR[i]
20182 TOCARR_ROT_ANGLE_OFFSET[i]
20184 TOCARR_BASE_FRAME_NUMBER
20188 TOCARR_FINE_LIM_LIN
20190 TOCARR_FINE_LIM_ROT
20202 WAB_MAXNUM_DUMMY_BLOCKS
20204 WAB_CLEARANCE_TOLERANCE
20210 CUTCOM_CORNER_LIMIT
20220 CUTCOM_MAX_DISC
20230 CUTCOM_CURVE_INSERT_LIMIT
20240 CUTCOM_MAXNUM_CHECK_BLOCKS
20250 CUTCOM_MAXNUM_DUMMY_BLOCKS
20252 CUTCOM_MAXNUM_SUPPR_BLOCKS
1548
Description
Maximum value of D number
Maximum number of D numbers per tool
Number of all sum offsets in NCK
Number of additive offsets per cutting edge
Properties of additive offsets in the TO area (SRAM)
Assign orientation to cutting edges
Tool environments in the TOA area (SRAM)
Description
Meaning of the address extension with T, M tool change
Definition of initial control setting after RESET/part pro‐
gram end
Tool length compensation at power-up (Reset/TP end)
Preselected tool on RESET
Troubleshooting for the CUTMOD function
Active toolholder on RESET
Initialize CUTMOD for POWER ON
Tool cutting edge length compensation at power-up
(Reset/TP end)
Additive offset effective at RESET
Transformation data record at power up (Reset/TP end)
Rotary axis increment of the toolholder with orientation
capability
Rotary axis offset of toolholder with orientation capabil‐
ity
Number of the basic frames to accept the table offset
Limit linear fine offset TCARR
Limit of the rotary fine offset TCARR
Maximum number of blocks with no traversing motions
with SAR
Direction reversal for WAB
Max. angle for intersection calculation with tool radius
compensation
Maximum value for DISC
Maximum value for intersection calculation with TRC
Blocks for predictive contour calculation with tool radius
compensation
Maximum number of blocks without traversing motion
for TRC
Maximum number of blocks with compensation sup‐
pression
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Basic Functions