REORG
The (only) writable variable $A_MONIFACT, which is defined here, is stored by main-run data.
Since the write process takes place synchronously to the main run, no special measures are
required for Reorg.
18.14.2
SD42935 expansions
SD42935
Which of the wear components are to be transformed and which are not to be transformed in
conjunction with the functions TOWMCS and TOWWCS can be defined via the setting data:
SD42935 $SC_WEAR_TRANSFORM (transformation of wear values)
18.15
Examples
18.15.1
Toolholder with orientation capability
18.15.1.1
Example: Toolholder with orientation capability
Requirement
The following example uses a toolholder, which is described fully by a rotation about the Y
axis. It is therefore sufficient to enter only one value to define the rotary axis (block N20).
Blocks N50 to N70 describe an end mill with radius 5 mm and length 20 mm.
Block N90 defines a rotation of 37 degrees about the Y axis.
Block N120 activates the tool radius compensation and all settings are made to describe the
compensation in the following blocks with a rotation of 37 degrees about the Y axis.
N10
N20 $TC_CARR8[1] = 1
N30
N40
N50 $TC_DP1[1,1] = 120
N60 $TC_DP3[1,1] = 20
N70 $TC_DP6[1,1] = 5
N80
N90 ROT Y37
N100
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
; Definition of toolholder 1
; Component of the first rotary axis in
the Y direction
; Definition of tool-compensation memory
T1/D1
; End mill
; Length 1
; Radius
; 37-degree rotation about y axis
W1: Tool offset
18.15 Examples
1535