>240VA
CAUTION: Hazardous energy present. Voltages with hazardous energy might cause heating when
shorted with metal, which might result in splattered metal, burns, or both. (L005)
2. Remove the two cover screws, one from each side of the cover.
3. Press both buttons on the top cover to release the latches as shown in Figure 64, and push the cover
back about 0.5 in (1 cm) until it stops. If the buttons do not easily press down, partially remove the
drives directly under the buttons.
Figure 64. Releasing and opening the cover
4. Lift up the front of the cover up and remove it from the system.
Installing the service access cover on an 8001-22C or 8005-22N system
Learn how to install the service access cover on a rack-mounted IBM Power System S822LC for Big Data
(8001-22C) or the IBM CS822 (8005-22N) system.
About this task
Attention: For safety, airflow purposes and thermal performance, the service access cover must be
installed and fully seated before you power on the system.
Procedure
1. Place the rear of the cover on the system. Pivot to front of the cover down until it rests on the system.
Installing and configuring the system
103