Installing The Cover - IBM X 330 Series Installation Manual

8. If you have other options to install, install them now. Otherwise, continue with

Installing the cover

Complete the following steps to install the server cover:
1. Clear any cables that might impede the replacement of the cover.
2. Install the cover by placing it into position and sliding it forward. Make sure that
3. Install the screws and secure the cover as shown.
4. Install the server in the rack. See "Rack installation considerations" on page 16
5. Continue with "Working with cables" on page 16 for the instructions needed to
Slot
Top view of
heat sink
Terminator card
"Installing the cover".
Important: Before sliding the cover forward, make sure that all of the tabs on the
cover will engage the ledge at the front of the server properly. If all the tabs do not
engage the ledge properly, it will be extremely difficult to remove the cover later.
the cover engages the tabs at the front and rear of the server.
and see the Rack Installation Instructions that come with your server.
cable the server.
Heat sink release
lever
Clip
Heat sink
Microprocessor
Screws
Chapter 2. Installing options
15