Mitsubishi Electric Melsec Q Series User Manual page 55

2 USING THE E-MAIL FUNCTION
First device
Second device
Third device
n-1 device
n device
2 - 27
(2) Data configuration in CSV format
Data in CSV format can be used as control data for the cell units in Excel, etc.
Data in CSV format handled by the Ethernet module is the data expressed as
follows.
• 1 word (16 bits) binary data is converted to four digit ASCII code when
expressed as a hexadecimal. (4 bytes of ASCII code)
• When handling multiple word data, insert comma data between each word
(4 bytes of ASCII code).
Data designated by the MSEND instruction or data subject to the news function
is sent in the following arrangement.
(a) Arrangement of data sent by the MSEND instruction
1) In addition to the data conversion and insertion described above, CR
(code: 0D
2) The arrangement of data sent in CSV format is shown below.
D0
D8
D16
D24
(b) Arrangement of data sent using the news function
1) In addition to the data conversion and insertion of comma data
described above, CR (code: 0D
each setting device range.
2) A maximum of 16 types of device ranges can be set for news data.
See Section 2.9 for details.
3) The arrangement of data sent in CSV format is shown below.
W0 W1
, ,
D0 D1
, ,
[CR+LF]
M0 to M15 M16 to M31
,
X10 to X1F X20 to X2F X30 to X3F
, ,
B10 to B1F B20 to B2F B30 to B3F
, ,
Data section can have a maximum of 1920 bytes (total points for the device).
) and LF (code: 0A
H
D1 D2
, , ,
D9 D10
, , ,
D17 D18
, , ,
D25 D26 [CR + LF]
, ,
8 device
(8-word unit)
W2
,
D2
,
,
B60 to B6F
,
) are inserted for each 8 words of data.
H
D7 [CR + LF]
D15 [CR + LF]
D23 [CR + LF]
) and LF (code: 0A
H
W5 [CR+LF]
D50
X70 to X7F [CR+LF]
[CR+LF]
MELSEC-Q/L
) are inserted for
H
[CR+LF]
2 - 27