Settings For Accessing Other Stations - Mitsubishi Electric Melsec Q Series User Manual

3 COMMUNICATIONS VIA OTHER NETWORKS

3.3 Settings for Accessing Other Stations

3 - 5
This section explains the parameters and setting items that need to be set with a
programming tool to access other stations via the Ethernet using the CC-Link IE
Controller Network, CC-Link IE Field Network, MELSECNET/H, MELSECNET/10 relay
communication function.
(1) Network parameter
1) Network No., group number, station number (station No.), etc. for using the
Ethernet module are set on this screen.
2) Make sure to set the values by seeing the User's Manual (Basic).
(2) Station No. <-> IP information setting
1) The Ethernet's routing method, correspondences of the Ethernet module's IP
address and Network No./station number, etc. for using the CC-Link IE
Controller Network, CC-Link IE Field Network, MELSECNET/H,
MELSECNET/10 relay communication function are set on this screen.
2) Set these values by seeing Section 3.3.1.
(3) Routing information setting
1) On this screen, the routing parameters between Ethernet modules for
accessing other stations on other networks are set, in the same way as for
the routing parameter settings of other networks.
The Network No. and station number of the first communication relay
station as seen from the local station are set.
2) These settings are required for a station where two or more Ethernet
modules or network modules are connected.
3) Set these values by seeing Section 3.3.3.
MELSEC-Q/L
3 - 5