Mitsubishi Electric Melsec Q Series User Manual page 198

6 DEDICATED INSTRUCTIONS
Response data (All values are set by the system)
When "all stations or a group (FF
will be stored.
Device
(D1) Request type
(D1) + 1 Sub-request type
Functions
6 - 31
or 81 to A0
H H
Item
0090 : When station No. is specified in (S1)+5
H
0001 : Remote RUN
H
0002 : Remote STOP
H
POINT
(1) Remote RUN/STOP becomes valid when the RUN/STOP key switch of the target
station's Q/L/QnACPU is "RUN".
(2) Remote RUN/STOP cannot be executed when the system protection is activated
on the target station's Q/L/QnACPU.
(3) When other station has executed a remote STOP/PAUSE operation on the target
station, the RUN request cannot be executed if the mode of (S2) + 2 is "Do not
force execution (0001
(4) Resetting the Q/L/QnACPU of the target station where a remote STOP operation
has been executed erases the information of the remote STOP.
(5) The clear mode ((S2) + 3) designates how the clear (initialization) processing of
the Q/L/QnACPU device memory should be performed when the Q/L/QnACPU
starts performing calculations after a remote RUN request has been issued to it.
The Q/L/QnACPU executes the designated clear and then goes into the RUN
status according to the parameter settings (PLC File
(6) The number of resends ((S1) + 7) must be set at every instruction execution.
(1) This instruction sends the request data designated in (S2) of the local station to
the station connected to other networks or Ethernet that has been specified with
the network number and station number in the control data to make a service
request.
When the request to the target station is completed, the completion device
designated with (D2) turns on.
[Local station]
Programmable
controller CPU
(S2)
REQ
(2) Device data can be sent from stations connected to other networks or Ethernet
having the specified numbers, in addition to stations connected to the local
station's network.
)" is specified in Target station No. ((S1)+5), no response data
H
Description
)."
H
[Response station]
Ethernet module
Channel 1
Channel n
Channel 8
MELSEC-Q/L
Remote RUN
Initial Device Value).
Programmable
controller CPU
RUN/STOP
Clock data
reads/writes
Ethernet
Remote STOP
Ethernet module
6 - 31