Mitsubishi Electric Melsec Q Series User Manual page 105

4 WHEN THE Q/LCPU ACCESSES THE PROGRAMMABLE CONTROLLER
OF ANOTHER STATION USING THE DATA LINK INSTRUCTION
4 - 14
(b) RECV instruction (for receive by the main program)
[Network number designation]
Receive command
JP.RECV
[Network module/Ethernet module start I/O signal designation]
Receive command
GP.RECV
Jn Local station network number
Start I/O signal of the local station network module/ Ethernet
module
Un
Designate by higher two digits when the I/O signal is
expressed by three digits
Control data storage head device
(S) Designate the head device of the local station that stores
the control data.
Receive data storage head device
(D1) Designate the head device of the local station that stores
the receive data.
Receive completion device
Designate the device to turn on one scan when the
(D2)
receive is complete.
(D2) ................ OFF: Incomplete
(D2) + 1 .......... OFF: Normal
1: Bit device .................................. X, Y, M, L, F, V, B
2: Word device ............................... T, C, D, W, ST, R, ZR
3: Word device bit designation ......
Jn
(S) (D1)
Un
(S) (D1)
Setting details
ON: Complete
ON: Error
.
Word device Bit number
MELSEC-Q/L
JP: Exection
(D2)
during startup
GP: Execution
(D2)
during startup
Setting range
1 to 239 : Network number
254 : Network designated in the
valid module for other
station access
0 to FE
H
2
Word device
2
Word device
1
Bit device
Word device bit designation
3
4 - 14