Sending E-Mail (Main Text) By The Programmable Controller Cpu; When Sending Data As Main Text Of E-Mail - Mitsubishi Electric Melsec Q Series User Manual

2 USING THE E-MAIL FUNCTION

2.8 Sending E-mail (Main Text) by the Programmable Controller CPU

2.8.1 When sending data as main text of e-mail

ZP.MSEND
QCPU QJ71E71
2 - 28
This section explains how to send the main text of e-mail using the dedicated MSEND
instruction available for the Ethernet module.
The following explains the MSEND instruction and program for sending e-mail.
The following illustration shows how the MSEND instruction is used to store data in the
main text of e-mail and send it to an external device.
1) 2) 3) 4)
(S1) (S2) (D)
"Un"
Subject + main text
E-mail address
(parameter setting)
I/O No.
1) I/O number of the Ethernet module
2) Control data (such as sending e-mail address)
This indicates the e-mail address of the transmission destination
device set on the Send E-mail Address Settings screen.
3) Sending e-mail (Subject + main text)
The Subject consists of No. of transmissions and the character data
specified by a sequence program. (It is not converted to ASCII format.)
Designate text data in ASCII characters in sequence programs.
4) Completion bit
5) Main text of e-mail
This indicates the character string designated by the MSEND
instruction.
It is not converted to ASCII format by the Ethernet module.
Designate the main text in ASCII characters in sequence
programs.
The following binary code data is processed as control codes:
0D0A
00
It is recommended to use 78 characters or less data when writing
each line of the main text (sending data). (Be sure to add a line
feed code CR+LF (0D0A
6) Attached file
No attached file can be sent when sending data as the main text of e-
mail.
: Line feed code CR+LF
H
: End of main text
H
MELSEC-Q/L
Desti-
nation
5) Main text of e-mail
) at the end of the main text lines.)
H
Mail server
2 - 28