Mitsubishi Electric Melsec Q Series User Manual page 136

5 WHEN USING FILE TRANSFER FUNCTIONS (FTP SERVER)
Command
rename Change the file name of a CPU module
user Enter user name and password for Ethernet module
status Display the operating information of a CPU module
stop Set a CPU module to STOP status
run Set a CPU module to RUN status
change Display/change the file attribute of a CPU module
Designate an access target CPU when configuring
cpuchg
the multiple CPU system or display the present
5
( )
access target CPU
password- Change status of remote password from unlock to
lock lock
password- Change status of remote password from lock to
unlock unlock
Set a file access password to an Ethernet module or
keyword-
display/clear the file access password set in an
5
set ( )
Ethernet module
Set a file access password (for read password) to
passwd-rd an Ethernet module or display/clear the file access
6
( ) password (for read password) set in an Ethernet
module
Set a file access password (for write password) to
passwd-wr an Ethernet module or display/clear the file access
6
( ) password (for write password) set in an Ethernet
module
5 - 3
Function
4 This command becomes disabled with the switch of a programmable controller
CPU set to STOP.
5 This command can be used only in a Q series Ethernet module.
6 This command can be used only in an L series Ethernet module.
POINT
Some of the commands in the table may not operate as described in this manual
depending on the client-side FTP application.
See the manual for the FTP client side (external device), and confirm the functions
and operation methods as well.
Programmable controller CPU status
During RUN
During
Write enable Write disable
STOP
setting setting
4
( )
MELSEC-Q/L
Remote password
While
While locked
unlocked
Ethernet module-FTP
server dedicated
commands
Remarks
—
5 - 3