Appendix; Appendix 1 Self-Test Page - SNBC KIOSK Series User Manual

BK-L216II Manual
＊
Paper near end alarm acts only as a prompt for users, not error status. Therefore when this alarm is given, printing task
can still be sent.
＊
If paper jam in the cutter, first clear up the jammed paper then press CUTTER button to reset the cutter.

Appendix

Appendix 1 Self-test page

Print self-test page in the following steps:
Turn off printer power, hold the FEED button for at least 1 second while turning on the printer. The printer will start to print
a self-test page. Take 203 dpi Serial+USB interface model as an example, the self test paper is shown as follows:
***BK-L216II(200) TEST FORM***
Boot Firmware
Main Firmware
H/W Parameters
H/W ID
Flash Memory Size
Flash Logos Size
Resolution
Print Width（Max）
Fixed Left Margin
Fixed Right Margin
Print Speed（MAX）
Dark Scale
Cutter
PRSENTER
Bundelr Mode
Communication Interface
Rx Buffer Size
Interface Type1
Baud Rate
Data Bits
Stop Bits
Parity
Flow Control
Command CR
Data Receive Error
Interface Type2
Resident Fonts
Font0(12X24)
Font1(9X17)
Code Pages
SNBC
:FV1.010
:FV1.000
:BK-L216II2(U) 1
:1M bytes
:64k bytes
:203×300DPI
:216mm
:0mm
:0mm
:100mm/s
:110
:Enabled
:Enabled
:Command Control
:4096 bytes
:RS232
:38400bps
:8
:1
:NONE
:DTR/DSR
:Ignored
:Print '?'
:USB_BK-L216II_1
:English
:English
:437,850,852
- 42 -