Replacement - Henny Penny 500 Service Manual

2 2 . . 1 1 3 3 . . 5 5 R R e e p p l l a a c c e e m m e e n n t t M M e e r r c c u u r r y y
N N O O T T E E :
Replace contactor as follows:
Remove only those wires directly connected to the contactor being replaced.
1 1 ) )
Label the wires.
On the mercury heat contactor, use a 5/16" socket or nut- driver and loosen four
2 2 ) )
nuts securing contactor to shroud. Slide contactor up and then pull out through
the slotted holes in the base of the contactor.
On the primary contactor, remove two mounting screws on the base plate and
3 3 ) )
remove contactor.
Install the new contactor and tighten the two mounting screws.
4 4 ) )
Connect the labeled wires to their respective positions.
5 5 ) )
Install the control panel.
6 6 ) )
Reconnect power to the fryer and test the fryer for proper operation.
7 7 ) )
36
T T o o a a v v o o i i d d e e l l e e c c t t r r i i c c a a l l s s h h o o c c k k o o r r p p r r o o p p e e r r t t y y d d a a m m a a g g e e , , m m o o v v e e t t h h e e
p p o o w w e e r r s s w w i i t t c c h h t t o o o o f f f f a a n n d d d d i i s s c c o o n n n n e e c c t t m m a a i i n n c c i i r r c c u u i i t t b b r r e e a a k k e e r r , , o o r r
u u n n p p l l u u g g c c o o r r d d a a t t w w a a l l l l r r e e c c e e p p t t a a c c l l e e . .
Mercury contactors were used on all fryers until 2011.
Replacement contactors cannot be shipped to states where
regulations forbid use.