Henny Penny 500 Service Manual page 249

8 8 . . 2 2 1 1 I I n n s s p p e e c c t t C C r r o o s s s s A A r r m m C C o o m m p p o o n n e e n n t t
Refer to the Annual Inspection Video on
3. Slide the "NO GO" side of the gauge
over the entire width of the latch. If
the lip of the latch inserts into the
cut out in the gauge, this latch fails
inspection and
replaced.
L L a a t t c c h h S S p p r r i i n n g g I I n n s s p p e e c c t t i i o o n n
Make sure the latch spring and all of its
components (latch spring, latch pin,
spacers, and C-clip retainer) are not
broken, not missing
correctly. If any components are broken,
damaged, missing
incorrectly, this fryer would need to be
taken out of service until which time the
components can
installed correctly. The latch spring is
installed correctly if the label "FRONT
THIS SIDE" is mounted to the front of
the latch.
A. C-Clip Retainer
B. Spacers
C. Latch Spring
D. Latch Pin
Vimeo.
needs to be
and installed
or installed
be replaced and
235