Henny Penny 500 Service Manual page 70

Remove the broken spring.
4 4 ) )
The new spring is placed in the loading tool so that the spring coil is laying in the
5 5 ) )
u-shaped center of the tool. The perpendicular shaft is placed in the stationary
hook of the tool, and the parallel shaft is placed so the adjustable hook will
tighten it down.
Tighten the handle on the tool as far as it will go.
6 6 ) )
Place the spring (loaded in the tool) into position so that the u-shaped center of
7 7 ) )
the tool is towards the front of fryer and the tool handle is toward the top of the
fryer.
Replace hinge pin and Tru-Arc locks. Loosen and remove the tool.
8 8 ) )
Reinstall the lid, see
9 9 ) )
2 2 . . 1 1 6 6 . . 1 1 2 2 L L a a t t c c h h S S p p r r i i n n g g I I n n s s t t a a l l l l a a t t i i o o n n
The latch on the crossbar must have the external coil-type latch spring mounted on
latch pin. If a latch spring is weak or broken, it must be replaced with a new spring,
part number 33480.
56
2.16.10.3 Lid Cover Installation , page
T T o o a a v v o o i i d d s s e e v v e e r r e e b b u u r r n n s s a a n n d d i i n n j j u u r r i i e e s s m m a a k k e e s s u u r r e e t t h h e e l l i i d d i i s s
s s e e c c u u r r e e d d u u r r i i n n g g a a c c o o o o k k c c y y c c l l e e . . T T h h e e l l a a t t c c h h s s p p r r i i n n g g m m u u s s t t b b e e i i n n
g g o o o o d d w w o o r r k k i i n n g g o o r r d d e e r r
i i l l l l u u s s t t r r a a t t i i o o n n s s b b e e l l o o w w . . I I f f t t h h e e l l a a t t c c h h s s p p r r i i n n g g i i s s w w e e a a k k , , b b r r o o k k e e n n , , o o r r
m m o o u u n n t t e e d d b b a a c c k k w w a a r r d d s s , , i i t t w w i i l l l l p p r r o o v v i i d d e e l l i i t t t t l l e e f f o o r r c c e e a a g g a a i i n n s s t t t t h h e e
l l a a t t c c h h . .
55.
a a n n d d p p r r o o p p e e r r l l y y i i n n s s t t a a l l l l e e d d , , s s e e e e