Henny Penny 500 Service Manual page 75

2 2 . . 1 1 6 6 . . 1 1 5 5 L L i i d d L L i i m m i i t t S S t t o o p p A A d d j j u u s s t t m m e e n n t t
The lid limit stop, with proper adjustment, prevents unnecessary overtightening of the
spindle, and as a result, extends the life of the lid gasket.
Loosen the Allen set screws on the bottom of the collar of the limit stop
1 1 ) )
assembly.
Turn the inner collar of the limit stop clockwise as far as possible. Find the small
2 2 ) )
hole in the inner collar and use a small Allen wrench or Phillips head to help in
turning the collar.
Close lid and turn spindle until lid gasket meets the top of the vat (frypot) rim.
3 3 ) )
From this position, turn spindle at least 3/4 of a turn, but not over one full turn.
4 4 ) )
After rotating spindle to this point, slightly extend the spindle past this position.
5 5 ) )
The spindle should then be at the seven o'clock position. It may be necessary to
remove knobs and change their position in order to align the red knob with the
61