Henny Penny 500 Service Manual page 88

2 2 . . 2 2 1 1 . . 1 1 R R e e p p l l a a c c e e S S o o l l e e n n o o i i d d V V a a l l v v e e A A s s s s e e m m b b l l y y
A A
74
1. Remove Tru-Arc retaining clip on top
of the coil housing.
2. Remove the nameplate and cover.
3. Do one of the following:
A. If only the coil is replaced, disconnect two
coil wires at the wire nuts in the coil
housing, remove the coil from the
housing, and then replace with the new
coil. Then replace nameplate, cover,
and Tru-Arc clip.
B. If the complete solenoid, or seals are
being replaced, continue on to step 4.
NOTICE : The wires may be connected
in any order.
4. Loosen the nut on the 1/2 inch
connector and pull piping conduit from
the valve case. Leave enough slack to
remove the coil housing and yoke.
5. If the core-disc assembly is sticking
due to buildup of shortening, breading
and food particles proceed with the
following steps.
A. Unscrew the solenoid bonnet assembly
from the solenoid valve body.
B. Remove the solenoid bonnet assembly
and the bonnet gasket.
C. Remove the core-disc assembly, core
spring retainer, and the core spring.
D. Wash all parts in soap and hot water.