Figure 8-1 Pfg 600 Weld Locations - Henny Penny 500 Service Manual

8 8 . . 6 6 I I n n s s p p e e c c t t t t h h e e F F r r y y P P o o t t
If oil accumulation can be seen from a weld, take the fryer out of service until the fry
pot is replaced. Contact Henny Penny with any questions regarding fry pot warranty.
Do the following:
1 1 ) )
• PFG-600: Remove the heat shield plate above the burner to gain better visibility
inside the burner box.
• PFE-500: Remove side panels of fryer.
Do the following:
2 2 ) )
• PFG-600: Use a flashlight and inspection mirror to inspect the welds (A and B) of the
fry pot and drain stem weld.
• PFE-500: Use a flashlight to inspect the corner welds, drain stem and the pot to
countertop welds.
220
T T o o a a v v o o i i d d f f i i r r e e , , i i f f o o i i l l a a c c c c u u m m u u l l a a t t i i o o n n c c a a n n b b e e s s e e e e n n f f r r o o m m a a w w e e l l d d , ,
t t a a k k e e t t h h e e f f r r y y e e r r o o u u t t o o f f s s e e r r v v i i c c e e u u n n t t i i l l t t h h e e f f r r y y p p o o t t i i s s r r e e p p l l a a c c e e d d . .

Figure 8-1 PFG 600 Weld Locations