Henny Penny 500 Service Manual page 244

8 8 . . 1 1 7 7 . . 2 2 P P l l u u m m b b i i n n g g L L e e a a k k s s i i n n F F i i l l t t r r a a t t i i o o n n
Remove the right side panel from the fryer.
1 1 ) )
Use a flashlight to inspect the fittings of the filtration plumbing and between the
2 2 ) )
filter pump and motor for oil leaks
Drain about half the vat of oil to the drain pan.
3 3 ) )
Turn the power switch to the pump position to pump the oil back up to the fry
4 4 ) )
pot.
While the oil is pumping, use a flashlight to inspect for oil leaks.
5 5 ) )
If leaks are detected with plumbing, disassemble, clean, and reassemble the
6 6 ) )
fittings using pipe thread sealant on threaded fittings, or replacing any worn
sleeve fittings on compression fittings.
If leaks are detected between the filter pump motor and the filter pump, replace
7 7 ) )
the seal kit.
230