Henny Penny 500 Service Manual page 252

8 8 . . 2 2 2 2 L L u u b b r r i i c c a a t t e e C C r r o o s s s s A A r r m m C C o o m m p p o o n n e e n n t t s s
Follow these steps to reduce wear on the spindle, thrust ball, ball seat, hinge spring,
and locking pin. Refer to the
O O b b j j e e c c t t i i v v e e : Reduce wear on the spindle, thrust ball, ball seat, hinge spring, and
locking pin.
238
6. If the hinge spring is broken. It will not
fail the inspection but the spring would
need to be replaced ASAP.
A. Retaining Clip
7. Ensure four bolts are installed in the
hinge plate at the rear of the fry pot.
Check to make sure these bolts are
snug. If any bolts are missing, take the
fryer out of service until they can be
replaced.
Annual Inspection Video on Vimeo.