Henny Penny 500 Service Manual page 76

red knob on the lid cover latch. When in the normal operating position, both red
knobs should be aligned.
NOTICE:
Adjust the limit stop by turning it clockwise until it stops against the bottom hub
6 6 ) )
of the spindle.
Tighten Allen set screws.
7 7 ) )
If the lid cover fails to seal properly, steam will escape around the gasket during
8 8 ) )
the frying operation. The limit stop should be readjusted. This time turn the
spindle screw one full turn after the initial contact of the lid gasket against top of
the vat (frypot) rim.
2 2 . . 1 1 6 6 . . 1 1 6 6 S S p p i i n n d d l l e e S S c c r r e e w w A A s s s s e e m m b b l l y y
This assembly is used to tighten the lid cover against the vat (frypot) flange.
Loosen the set screw in the limit stop collar and loosen the limit stop.
1 1 ) )
Disengage the crossbar from the lid cover as described in the "Lid Cover
2 2 ) )
Removal". Leave the lid cover in position on the vat (frypot) rim with the
crossbar in the upright position.
Turn the spindle so the pin in the locking collar will be exposed.
3 3 ) )
Remove pin and locking collar. Use a small diameter punch and a hammer to
4 4 ) )
drive out the pin from the locking collar. Remove the locking collar.
62
The seven o'clock position is only to allow slight
additional turning of the spindle to relieve any side
pressure that could hold the locking pin in the locking
collar after all pressure has been released from the vat
(frypot).