Henny Penny 500 Service Manual page 84

To reassemble, place rotor on drive shaft, and place roller into rotor.
3 3 ) )
NOTICE:
2 2 . . 1 1 7 7 . . 8 8 P P u u m m p p R R e e m m o o v v a a l l
If the pump needs to be replaced, loosen one inch nuts from the outflow and
1 1 ) )
inflow lines. Then remove the two bolts holding the pump to the motor with a 1/2
inch wrench.
Shaft seal should remain on the motor shaft, or if leaking, could be replaced at
2 2 ) )
this time.
70
A small amount of grease might be needed to hold the
bottom roller into place until cover plate is put on. Make
sure O-ring is in proper position on plate.