User Origin Method - Mitsubishi Electric RH-FRH Series Instruction Manual

5.6.4 User origin method

CAUTION
The procedure for setting the origin with the user origin method is explained below.
This operation is carried out with the teaching pendant. Set the [ENABLE] switch on the teaching pendant to
"ENABLE" to enable the teaching pendant.
The operation method is shown below.
When setting the origin for the first time using this method, carry out the operations in order from step "1)". For
the second and following time, move the robot arm to the user origin position with jog operation, and accurately
position all axes. Then start the procedure from step "4)".
1) Determine the user origin position
Move the robot to the position to be set as the origin with jog operation. Refer to
the operation"
CAUTION
2) Enter the JOINT jog mode, and display the joint coordinates on the teaching pendant screen. Record the
value of the axis for which the origin is to be set.
3) Input the value recorded in the "user designated origin parameter (USERORG)".
The parameter details and input methods are described in the separate "Instruction Manual/Detailed Explana -
tion of Functions and Operations". Refer to that manual and input the user designated origin position.
<MENU>
1.FILE/EDIT
3.PARAM.
5.SET/INIT.
123
<ORIGIN/BRAKE>
1.ORIGIN
123
<ORIGIN>
1.DATA
3.TOOL
5.USER
123
Before using this method, the origin must be set with the other method.
The setting method is explained in
for details on the jog operation.
Choose the user origin position as the position where it doesn't move by the gravity.
This position is left as a guideline to position all axes with jog operation when setting
the origin again with this method.
2.RUN
4.ORIGIN/BRK
6.ENHANCED
CLOSE
2.BRAKE
CLOSE
2.MECH
4.ABS
CLOSE
Page 142, "Table 5-15 ： Origin setting
4) Next, set the origin.
Display the menu screen.
5) Press the [4] key on the menu screen, and dis -
play the Origin/Brake selection screen.
6) Press the [1] key, and display the Origin setting
selection screen.
7) Press the [5] key, and display the User selection
screen.
5 Maintenance and Inspection
method".
Page 36, "2.3 Confirming
Resetting the origin 5-160