Unpacking; To Unpack The Machine - Stratasys Prodigy Plus User Manual

16 Setup

Unpacking

This section describes the recommended procedures for
unpacking and preparing Prodigy Plus for its first use.

To unpack the machine:

1. Before unpacking machine, use a forklift to move it near its
intended location.
2. Remove the plastic banding from around the cardboard,
and slide the cardboard up and off the pallet.
3. Using the forklift, place the unit in its final location.
4. Cut and remove the cable ties that secure the extrusion
head to the Z-axis frame (see
Figure 2: Cable ties securing the extrusion head to the Z-axis frame
Prodigy Plus User Guide
Before powering on Prodigy Plus, if you
have not yet done so, cut and remove the
plastic cable ties that secure the extrusion
head to the Z-axis frame (see
The machine will be damaged if powered
on while the head is tied to the frame.
Figure 2).
WARNING
Figure 2).