Unpacking The Printer - Stratasys F770 Site Preparation Manual

Site Preparation Guide

Unpacking the Printer

1. Inspect the Tilt Indicators (2) and ShockWatch indicator affixed to the exterior of the
cardboard box. If possible, take a picture of these indicators to share with your installation
representative. If damage is detected upon installation, this photo will assist your
installation representative in determining the cause of damage
2. Using a drill with a Phillips drive bit, remove the screws (approximately 18) securing the top
panel assembly to the crate. Set aside the top panel.
Make sure that there is at least 70 inches (178 cm) of clearance around the base of
the shipping crate for removing shipping materials.
If damage has been detected, do not continue unpacking until a certified
Stratasys technician has been contacted.
Figure 7: Shipping Crate Damage Indicators
Shock Indicator
Black dots on exterior of crate panels indicate wood screw locations.
Figure 8: Removing the top crate panel
Top panel wood screw
(Qty 18)
Tilt Indicator
Preparing for Installation
(Figure 7).
Page 9