Stratasys Prodigy Plus User Manual page 58

58 Troubleshooting
b. If the purge was successful:
i.
ii.
iii. Verify material continues to extrude through both
iv. Push Done. The panel displays Is material
v.
c. If material did not purge, continue with the following
steps.
3. Snip both filaments approximately 1 inch from the fixed
part of the head (see
Figure 21: Materials coming out of feed tubes
Prodigy Plus User Guide
Continue to run both filament motors forward and
slowly swivel the head closed. Be careful to not
pinch the filament or the head wiring when closing
the head.
Once the head is closed, tighten both of the swivel
head screws, ¼ turn.
tips for an additional 30 seconds, then press Stop
to halt extrusion.
loaded?
Press Yes. The panel displays Exiting
maintenance and you can now resume normal
operation.
Figure 21).