18 Setup
2. Connect the female end of the power cord directly into the
rear of the cabinet.
3. Switch the circuit breaker to the on (up) position.
The machine is now ready for powering on.
Powering On Prodigy Plus
To power on Prodigy Plus, simply flip the large red power switch on
the lower right side of the machine (see
boots up in three to seven minutes.
Prodigy Plus User Guide
Prodigy Plus's build chamber and
extrusion-head tip get very hot! The
chamber and head tip reach temperatures
of approximately 75° C (167° F) and 280° C
(536° F) respectively. Use the leather safety
gloves provided in the Startup Kit when
working inside the machine.
Figure 4: Location of Power Switch
WARNING
Figure
4). Prodigy Plus
Need help?
Do you have a question about the Prodigy Plus and is the answer not in the manual?