Power Connections; To Prepare All Power Connections - Stratasys Prodigy Plus User Manual

5. After uncrating and removing the cable ties, inspect the
machine and report any shipping damage to the carrier.

Power Connections

This section discusses the procedure for preparing all power
connections for the machine.
Prodigy Plus is provided with two power cords: one for 110 V and
one for 220 V.

To prepare all power connections:

1. Connect the male end of the supplied power cord directly
into a grounded electrical outlet, as shown in
below. If using a UPS, connect the cord directly into the
UPS.
Figure 3: Connecting to a grounded electrical outlet
Before connecting power to the machine,
ensure that the circuit breaker located in the
rear of the machine is in the off (down)
position.
Connect the cord directly into the
receptacle or UPS. Do not use an
extension cord or power strip.
Important
WARNING
Prodigy Plus User Guide
Setup 17
Figure 3