Table of Contents
Advertisement
Site Preparation Guide
Unpacking and Positioning the Printer
1. Inspect the Tilt Indicators (2) and ShockWatch indicator affixed to the exterior of the
cardboard box. If possible, take a picture of these indicators to share with your installation
representative. If damage is detected upon installation, this photo will assist your
installation representative in determining the cause of damage
Tilt
Indicator
2. Carefully cut the shipping bands (3) and remove the tape
Make sure that there is at least 70 inches (178 cm) of clearance for the printer before
you begin the process of unpacking the printer.
Figure 3: Shipping Crate Detail (Back View)
Warning: Personal Injury Hazard
Shipping bands are very tight; when cutting shipping bands they may pop open with
force. Wear safety glasses when removing the shipping bands.
Preparing For Installation
(Figure
3).
Shipping
Bands (3)
ShockWatch
Indicator
(Figure
3).
Tape
Tilt
Indicator
Page 8
Advertisement
Table of Contents
