Canceling A Job; Removing A Completed Part; To Cancel A Job; To Remove A Completed Part - Stratasys Prodigy Plus User Manual

2. Press Start Model to start modeling.
Prodigy Plus may require a few minutes to warm up to
build temperatures. You can view the temperature values
rising in the display.

Canceling a Job

You can cancel a job at any time while the part is being built.

To cancel a job:

1. Press Pause.
2. Once Prodigy Plus stops building, press Cancel Build.
The panel displays Are you Sure?
3. Press Yes. The panel displays Build Stopped and the
part name. The panel prompts you to remove the part and
replace the substrate (plastic modeling base). Once the
chamber door has been opened and closed, the panel
asks: Part Removed?
4. Press Yes only after removing the part using the
instructions in the following section,
Completed

Removing a Completed Part

When the part has completed, the panel displays Completed
Build, and the file's name. It also shows Remove Part and
Replace Substrate.

To remove a completed part:

1. Open the modeling chamber door.
Part.
If you press Yes before removing the part,
the machine can be damaged, and a service
call will be required.
Removing a
WARNING
Prodigy Plus User Guide
Operation 37