If the machine was off and is at room temperature, it
requires approximately 30 minutes to warm up before
you can perform any functions. Temperatures are
factory-preset and not adjustable. The panel displays
the head and envelope temperatures while Prodigy Plus
is warming up and cooling down.
For safety, the head and platen does not move while the
chamber door is open. During warm-up and operation, a
solenoid triggers the door lock. The door can be opened
only when Prodigy Plus is not building a part, getting
ready to build a part, or in pause status.
Powering Off Prodigy Plus
If the system is powered off during a build, the part will
be lost. You should complete the current build and
unload the material before a planned power-off.
If you wish to power-off Prodigy Plus, simply flip the large red
power switch on the lower right side of the cabinet (see
page
18). You can do this at any time without harming the machine.
No other steps are necessary. If this is done while the machine is
building a part, the part will be lost. System cooling fans continue to
operate for several minutes ensuring a safe, systematic power
down and cooling of the system.
For extended non-use periods, unload the material
cartridges and then power off the system.
Note
Note
Note
Note
Prodigy Plus User Guide
Setup 19
Figure 4
on
Need help?
Do you have a question about the Prodigy Plus and is the answer not in the manual?